Maker reference only. Verify brand instructions, seller details, dimensions, and safety guidance for your own setup.
Start with one flat hot-pink flower blank and keep the little top hanging cap separate from the yellow center, because the pair reads as a slab-built flower with a short silver connector rather than sculpted petals. Cut both flowers from the same template, pierce the top cap before baking, and keep the tiny white highlight small so the center stays graphic.
A quick read on the clay method, surface finish, and effort level before you start gathering tools.
Dimensions, motif spacing, and step timing below are build-ready estimates inferred from the reference image and the listed technique. Verify measurements against your own setup before cutting or assembling.
Work in sequence so the form, thickness, surface detail, and finishing stay controlled from prep through bake.
Roll a hot-pink sheet and cut both flower fronts from the same template so the pair stays matched.
Cut the yellow center pieces and the small top cap from a thinner yellow sheet, then cut the tiny white highlight square if you want to match the reference closely.
Lay the yellow center onto the flower and refine the petal steps before the clay warms up and softens.
Pierce the top cap while the flower is still flat so the connector rings will sit cleanly above the bloom.
Bake the pair flat on a tile, cool them fully, and clear the top holes only if they tighten during cure.
Add the silver connector rings and stud tops after cure, then leave the surface satin or lightly buffed.
Metal findings like posts, hooks, and jump rings may contain nickel or other allergens. If you have sensitive skin, choose surgical steel or titanium findings and test any sealant or coating on a small area before wearing.
Start with the core build kit, then add optional finishing or hardware only if it fits the version you want to make.
This core kit covers the repeatable clay, clean-cut tools, and hardware setup that most pixel earring variants share.
Some links in this build guide are affiliate links. If you buy through them, we may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases.
Matches the bright flower petals that carry most of the visual weight.
Useful for the stepped flower center and the small top cap above the bloom.
Needed for the tiny highlight square on the flower center.
Helps you keep both flower fronts the same slab thickness before cutting.
Useful for keeping the two flowers matched so they hang like a real pair.
Best for trimming the stepped petals and the center edges cleanly.
Useful for piercing the top hanging point in the yellow cap before baking.
Matches the silver stud tops visible in both images.
Lets you recreate the short connector run above each flower without adding a long chain.
Read the technique guides that matter most for building this piece, refining the finish, or avoiding the most common mistakes.
Graphic lips, eyes, mushrooms, and badge-like brooches are often easier to build as flat or gently domed pixel slabs. This guide covers crisp staircase edges, stacked layers, and ways to keep left and right pieces matched.
Many polymer clay drop earrings fail at the top: the stud sits too far back, the ring run is too long, or the drop twists sideways. This guide covers when to use visible stud toppers, when a flat pad is enough, and how to keep connector rings short and balanced.
Conditioning is not just softening clay. It is how you get cleaner slabs, steadier cane reduction, and sharper cut edges before the piece ever reaches the oven.
Explore adjacent builds with similar form, finish, or construction ideas.
Start with glue, post hardware, and hole placement that keep the drop centered, then use cutters to clean up the silhouette.
See all guides
Many makers reach for a two-part epoxy when they want slower setup time for post placement. Treat every adhesive as a test-first choice, especially if the clay, finding, finish, or prep routine changes.
Use flat-pad posts with clear material specs when you want a common, easy-to-source assembly starting point. If you add titanium, verify the listing details and material spec before you position it as a separate hardware option.
Keep this build handy while you test your own version.
Tag #ClayBakeStudio on Instagram or TikTok.
