Maker reference only. Verify brand instructions, seller details, dimensions, and safety guidance for your own setup.
Start with one full yellow butterfly blank and cut it twice from the same template, because the pair reads as mirrored slab butterflies with hot-pink wing fills rather than sculpted wings. Leave the body, antennae, and small square wing spots in yellow, pierce the top tab before baking, and add the short silver connector rings after cure.
A quick read on the clay method, surface finish, and effort level before you start gathering tools.
Dimensions, motif spacing, and step timing below are build-ready estimates inferred from the reference image and the listed technique. Verify measurements against your own setup before cutting or assembling.
Work in sequence so the form, thickness, surface detail, and finishing stay controlled from prep through bake.
Roll an even yellow sheet and cut both butterfly bases from the same template so the pair stays mirrored.
Roll a thinner hot-pink sheet and cut the wing fills to leave the yellow body, antennae, and little square spots exposed.
Lay the pink wing pieces onto the yellow bases and trim the stair-step edges while the clay is still cool.
Pierce the hanging tab at the top of each butterfly before baking so the silver rings will sit on the true centerline.
Bake the butterflies flat on a tile, cool them fully, and clear the holes only if they tighten during cure.
Add the short silver connector rings and the stud tops after cure, then buff lightly instead of flooding the surface with gloss.
Metal findings like posts, hooks, and jump rings may contain nickel or other allergens. If you have sensitive skin, choose surgical steel or titanium findings and test any sealant or coating on a small area before wearing.
Start with the core build kit, then add optional finishing or hardware only if it fits the version you want to make.
This core kit covers the repeatable clay, clean-cut tools, and hardware setup that most pixel earring variants share.
Some links in this build guide are affiliate links. If you buy through them, we may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases.
Matches the hot-pink wing fills that dominate the butterfly fronts.
Useful for the full butterfly base, exposed body, and small square wing spots.
Helps you roll even mirrored slabs before cutting both butterflies from the same template.
Keeps both butterflies the same thickness so they hang evenly.
Best for trimming the staircase wing edges and the tiny top tab cleanly.
Useful for piercing the hanging point in the top tab before baking.
Matches the silver stud tops visible in the product and lifestyle images.
Lets you build the short connector run between the stud and the butterfly without a long chain.
Read the technique guides that matter most for building this piece, refining the finish, or avoiding the most common mistakes.
Graphic lips, eyes, mushrooms, and badge-like brooches are often easier to build as flat or gently domed pixel slabs. This guide covers crisp staircase edges, stacked layers, and ways to keep left and right pieces matched.
Many polymer clay drop earrings fail at the top: the stud sits too far back, the ring run is too long, or the drop twists sideways. This guide covers when to use visible stud toppers, when a flat pad is enough, and how to keep connector rings short and balanced.
Conditioning is not just softening clay. It is how you get cleaner slabs, steadier cane reduction, and sharper cut edges before the piece ever reaches the oven.
Explore adjacent builds with similar form, finish, or construction ideas.
Start with glue, post hardware, and hole placement that keep the drop centered, then use cutters to clean up the silhouette.
See all guides
Many makers reach for a two-part epoxy when they want slower setup time for post placement. Treat every adhesive as a test-first choice, especially if the clay, finding, finish, or prep routine changes.
Use flat-pad posts with clear material specs when you want a common, easy-to-source assembly starting point. If you add titanium, verify the listing details and material spec before you position it as a separate hardware option.
Keep this build handy while you test your own version.
Tag #ClayBakeStudio on Instagram or TikTok.
